BerettaRacer wrote: ↑Wed Oct 07, 2020 12:03 pm
Asking for a friend only.
If my friend were to have an excess of target/ball ammo, but not enough factory hollowpoints for defense, is it legal in Fla to taper drill the tip of ball ammo to make poor mans hollowpoints?
Now you would lose some mass, probably from 115 gr down to 100 gr or so, but the better expansion might make up for that, and limit the over penetration of ball ammo.
Again, just asking for a friend.
This is just my opinion.
Please be a good friend to your "friend" and tell him:
1. He's a dumbass if he lived through any part of the Obama administration and doesn't have enough self defense ammo for every fighting gun he owns to feed it as long as he thinks he might need to if he can never buy another round of self defense ammo starting yesterday;
2. He's a cheap bastard if he can't learn how to reload and buy components and every piece of equipment he needs to do so including bullet molds of the desired configuration and enough wheel weights to make enough bullets to last as long as he needs assuming he can never buy another round of defensive ammo starting yesterday;
3. If he's guilty of #1 and #2 above, he's probably better off continuing to eat cereal in his underwear and play Call of Duty and binge watch Walking Dead in his mom's basement, and stay away from guns until he's matured quite a bit.
Again, just my opinion.
