Page 1 of 1
Mags dropping out of lower, best fix?
Posted: Sat Dec 12, 2020 1:51 am
by kayakingsteve
Been having an issue with mags, any type, any manufacture, spontaneously falling out of the lower while shooting or even cocking it a few times.
I played with screwing in the mag release a bit more to put more pressure on the spring and that fixed it, but seems like a Kludge.
Do these springs get weak often and is the SOP to just replace the spring?
Dumb questions, but... I'm dumb!
Re: Mags dropping out of lower, best fix?
Posted: Sat Dec 12, 2020 10:17 am
by Lastrites
Properly setup for the correct tension should look like the photo below, a turn or two less can create problems.
Re: Mags dropping out of lower, best fix?
Posted: Sat Dec 12, 2020 3:40 pm
by kayakingsteve
Mine looks more like the picture you showed me after I turned it in a few revolutions and it seems to have fixed the problem.
It doesn't seem like the mag release mechanism ties to anything else that a heavier spring would throw off. IS there any downside to having a stronger spring in there or even doubling up a spring?
Re: Mags dropping out of lower, best fix?
Posted: Sun Dec 13, 2020 9:08 am
by Lastrites
If it now looks like the picture and is working, you obviously didn't have it set correctly to start. Move on an enjoy, it shouldn't give you anymore grief and I certainly wouldn't try doubling up on the spring as it isn't needed. A few turns is all it takes bwtn working correctly and dropping mags inadvertently.
Re: Mags dropping out of lower, best fix?
Posted: Mon Dec 14, 2020 12:08 am
by kayakingsteve
Lastrites wrote: ↑Sun Dec 13, 2020 9:08 am
If it now looks like the picture and is working, you obviously didn't have it set correctly to start. Move on an enjoy, it shouldn't give you anymore grief and I certainly wouldn't try doubling up on the spring as it isn't needed. A few turns is all it takes bwtn working correctly and dropping mags inadvertently.
This is the part where my pride forces me to say that I bought it from someone already built. That said, honesty forces me to say that I'd have had no idea how many turns to thread it had I built my first one from scratch so probably would've had the same issue.
Re: Mags dropping out of lower, best fix?
Posted: Sat Dec 19, 2020 10:15 pm
by TC6969
My neighbor when I was 14 came over and fixed a sweated copper pipe that I had twisted off with pliers.
When he left, I walked him out, apologizing profusely.
He said "That's how ya learn,boy!"
Re: Mags dropping out of lower, best fix?
Posted: Tue Jan 05, 2021 7:13 am
by S&W collector
TC6969 wrote: ↑Sat Dec 19, 2020 10:15 pm
My neighbor when I was 14 came over and fixed a sweated copper pipe that I had twisted off with pliers.
When he left, I walked him out, apologizing profusely.
He said "That's how ya learn,boy!"
Yep similar to being a flat rate technician. "First you learn then you earn"