Florida Shooters Network

I have an integrally suppressed upper for Ruger Mark IV by TacSol and as much as I love it it has always been impossible to take apart after few hundred rounds through it. I had to unscrew the end cap and hammer it open with brass punch and rubber hammer. No amount of soaking in any sorts of cleaner would loosen it up. Not anymore! I found synthetic gun grease which I applied to the outer tube and after shooting it like this the baffle assembly came right out with very little pull.
If you’ve struggled with the same issue give it a try! Put a pea size amount of grease and apply on the internals.

HTH!

PS. I have not yet tried the aluminum based anti-seize one but I don’t think I need to.

Correction. I only really need to apply it to the outside of the metal sleeve holding the baffles. Supersonic cleaner or the dip take care of the rest after shooting

Nice!

This is what I use - just coat the baffles and they wipe clean after a few hundred rounds. Good stuff!

osprey21 wrote:Nice!

This is what I use - just coat the baffles and they wipe clean after a few hundred rounds. Good stuff!

Thanks! I’ll get some to try.